The vertical dryer adopt vertical equipment steel structure housing, lining equipped heat preservation material to preservation heat, in the inner of kiln, using multi-level high temperature castings, overlapping overlap, In the up, middle and down all relevant components, have several group vibrate, closure, temperature control, intelligent control system. Water vapor and smoke collected dust and ruled out by the draught fan whirlwind dust collector.
Principle
The key technology of vertical dryer is to control the flow rate and residence time of the material in dryer’s every areas, make the hot flue gas fully convection, radiation and heat conduction with the material, make the material as far as possible scattered in the dryer, in order to improve the contact area of the hot flue gas and material. At the same time, adopt the material drying parameter optimization microcomputer software technology, proceed online detection to the material moisture and gas temperature of the preheating zone, stoving zone and drying zone three areas, and proceed online adjustment to the heating ability, lead-wind quantity, secondary air distribution and heat supply capacity, material closure capacity, retention time and other system parameters, realize the system dynamic optimization balance, improve the system heat utilization rate.
When the kiln bottom temperature control instrument shows that the temperature reaches 400 °C show to 500 °C, the intelligent resistance twist-action material place controller instructions to elevator, lifting the less than or equal to 25 mm material to the preheating zone start preheat. When kiln crown’s temperature control instrument shows 150 °C to 250 °C, electric closure device automatic measure and baiting, into cross vibration chute starting secondary preheating and drying, material in the preheated process, structure natural loose, evenly into an array of interlap bulk material stack. Starting third drying, material top-down, free settling, and repeatedly proceed thermal radiation transmission with metal body of many groups of alternate overlap bulk material, then proceed mutual exchange with the continuous rising heat flow, moisture volatilizes gradually and into the high temperature funnel drying, make the material completely out of the water, when humidity measurement instrument issue desired value signal, the material to be automatic discharged, be output and put in storage by conveying equipment.
Features
The bulk material cone and vibration chute and other parts the vertical dryer used, are using anti-friction, high temperature resistant castings, corrosion resistance, need not change and lifelong use, vibration chute can effectively control the retention time of material, the material place machine and closure device, temperature control device, vibration chute part, can according to different requirements to adjust and control hub conversion, accurately send order to each place to coordinate performance.
No comments:
Post a Comment